Take care Jack. Hope the doc gets you fixed so you can get feelin' better.
I put the winder' job on the CNC last night. It ran for a while, but then stopped when the wire loom bound up, and stalled the stepper motors. So I just shut it down. This afternoon I redid the wire loom support back to the stock set up as it was the fastest fix to get it running again. I plan to run the first operation and shut it down, just to make sure it's working, so far so goota". I have a Cable Wire Drag Chain for it, but that will take a bit of fabricating to get it installed, so this will get me by for now. I'll be working in the office tomorrow, so I plan to fire it up in the morning to do the detail carving (that takes time) and watch it from the office monitor while I work on signs. I'd like to get the trim done A.S.A.P. because the busier I get with signs, the less likely it is I'll get it done. Then it's tough to get motivated to go back to it later. At least that seems to be my M.O.
Very cool today, but sunny. A group of us went to Chili's for lunch after Church, and before we knew it, it was 2:30p. That seems to be the group's M.O.
- Master Bathroom 3 31 19 1.jpg (168.07KiB)Viewed 2567 times
15th Annual DRAGLIST Nationals Sometime in 2020. Somewhere in the USA.