more hp for 83 monte carlo
Postby noco-kid » Sun Jun 21, 2009 7:11 pm
Ok first off I'm new here so I hope I'm posting in the right section,if not sorry.Ok well I have an 83 monte carlo.with a 305 there is nothing stock inside that motor I had a b&m 144 blower but took it off&need to pick up some hp.the crank was polished, the rods were destressed and balanced.the cam is a 194 duration and a 507 lift. it is really radical.the blower setteled it down. without the blower it is radical.the pistons are dish forged pistons.(8.5 to 1)this was a low compression for the blower. the lower end has nothing but ARP bolts in it to hold it together. the heads were treated to a 3 angle valve job and a set of double sprung Z- 28 springs. this motor was a mild 435 horse motor with the blower.this was dyno tested.can anybody give me any sugestions I have a 600 holley 4 barrel carb aluminum elderbrock intake,elderbrock headers&I also have duals,I'm a young guy this is my first car I'm gonna start building a 350 to put in it,but that's later.I was looking for a cold air intake like the ones k&n make but I can't find one for a carbarated engine,I just wanna take it to the track. Here outside of st.louis on the weeknds for fun...well any help will be appreciated so thanks in advance&sorry so long&about my typing