"Z" progress.

[WildcatOne]

Great job, ProZ! Uh...heh heh...I have a little something for you to use as a test run before you dig into that big Z project...Cheers, WC1

[pro70z28]

Thanks everybody. WC That is pretty cool. A louver punch, I need a louver punch.

[Solid Rock]

Here you go, pro.......

http://www.jalopyjournal.com/forum/show ... php?t=5581

[pro70z28]

That's a crude one Rocky but if it works, that's all that counts.


After using the stretcher/shrinker I noticed my mount stuck out too far, so I cut it back under the tool & re-welded it, all better now. I also made an aluminum tray to hold the S/S dies and the nibbler & Flange/hole punch tool. Just so I don't have to wonder where they are when I need em'.



Jeff ran his camaro on the jack stands yesterday to warm up the new rear end. Today he will be taking it out for a test run, so we will probably spend today cleaning up shops. Steaks on the grill after that.

BTW: NOTICE the bicycle wheel has a neeto reflector on it.........

[Solid Rock]

Once again, pro, good job.
I like the reflector.

What time will the steaks be ready.
I might be headed down that way a bit later today to see how the airbrush work is coming.

[Solid Rock]

another louver press. This one a bit more sophisticated.

http://www.jalopyjournal.com/forum/show ... 784&page=9

scroll down to post 171

[pro70z28]

Once again, pro, good job.
I like the reflector.

What time will the steaks be ready.
I might be headed down that way a bit later today to see how the airbrush work is coming.

What time ya' comin' down? I'd like to see the airbrush work. Our festivities don't start' 'til Cheryl gets home from work...... 5 or sp.

[WildcatOne]

I found this for Louvres.