Spent the long weekend getting as much done on the scaffolding as possible. I have a couple things to do yet but I'm a little closer to calling it a done deal. the track loader isn't big enough to set the deck on the trailer & still pull the forks out of the receivers. That & there's no way to easily pick it from the end. So I decided a tilting storage rack would solve both problems.
Flipped the deck upside down & built the flip part of the rack on top.
Once I had it far enough along to bolt down to the trailer I worked on the storage for the railing parts
Got it this far along & then took it back off to do a little more work on the railing storage and the final welding & paint.
Here's just the storage rack
And here's the rack loaded with railing parts & the deck in the pick position. I used Some Roll on bed liner on the top for a non-skid surface.
And the deck in the storage position. I sprayed rattle can undercoating on the bottom side of the plywood just because I had a few cans on the shelf.
Still a lot to do but it's getting closer.
