Page 3 of 5

Posted: Thu Feb 08, 2007 10:27 pm
by Lippy
Ok, Boyd, the hill turkeys have one leg shorter than the other, ...if he turns around, will he fall down? I mean a half a turn.? Or will he just lean? Or does it depend on how much he weighs and if he has good equalibrium? :shock: Or does quantum physics even enter into the equation.?? :lol:

Posted: Thu Feb 08, 2007 10:30 pm
by Lippy
If cubic means square, then how do you measure a round chamber for cubic centimeters?

Posted: Thu Feb 08, 2007 10:34 pm
by flyinhillbilly
If cubic means square, then how do you measure a round chamber for cubic centimeters?
you start in the corner.....duh!!!

Posted: Thu Feb 08, 2007 10:36 pm
by pro70z28
I think you have to melt the little cubics down to a liquid form and pour 'em in the round hole. But not too hot or it'll 'vaperate and that sometimes will throw off the 'quasion. I think that's where the square peg in a round hole came from. Although now that I think back I think it's a round peg in a square hole. I think if you want a square peg in a round hole you need to use the hill turkey inversion table.

Posted: Thu Feb 08, 2007 10:36 pm
by Lippy
Beeeeeeeeeeep, WRONG!! There is no corner!! :lol: :lol: :lol: :lol: Just funnin ya FHB!! :wink:

Posted: Thu Feb 08, 2007 10:38 pm
by Lippy
Gary, the short legged turkey equasion is only for metric cubits. :lol:

Posted: Thu Feb 08, 2007 10:40 pm
by flyinhillbilly
the hill turkey can only go short leg uphill ( makes them easy to hunt) if they turn the short leg downhill, they'll just go in circles

Posted: Thu Feb 08, 2007 10:40 pm
by pro70z28
If you just take the square root of the turkey leg & divide by a piece o' pie, it comes out to about the same. Give or take. :idea:

Posted: Thu Feb 08, 2007 10:42 pm
by Lippy
Ok, here's a real question that I don't understand. When talking about blowers, the rotor speed is one thing and I've heard people talk of rotor tip speed. If the tip of the rotor is part of the rotor, how can it be going any faster than the rotor itself?? By the tip, do they mean the edge of the rotor? That would mean possibly the outside edge of the rotor would be turning at a different rate than the center of the rotor. Is this what is meant? It's still the same isn't it?

Posted: Thu Feb 08, 2007 10:43 pm
by pro70z28
It's the Maypole effect. .............. Nuff said