Draglist.com Drag Racing

Opened the package from my landlord today. Here is what I found inside it.



Here is the hood burst panel out in the sun. See if it looks any nicer out in the sun.



Today's stuff was to install the clutch, bell housing, trans, and dirshaft



Nice looking valve covers. Too bad they won't work on the car.

That (decal) looks like it should fit.

Valve Covers, can the "vent" be welded up or are there more obstructions than that one?

that cover might be a little on the leaky side...

that cover might be a little on the leaky side...

A little silver duct tape & he's goota' to go.

After an evening of grinding it "Almost" fit. I was giving it a bit more, and went thru in the corner. At first I thought, well ok so it needs a patch. Then I went ahead and cut enough away to clear for real. The resulting hole is in the photo. It also still rubs a little on the rockers, so I scrapped the whole idea of using these. I called and ordered a fabricated style that will just slip right on with no evening of grinding and guessing.

Rapid

i spent a week clearencing all the handles on my coffee mugs so i could shut the cabinet door. 2 days later i found a nicer set free on craigslist that fit in there perfectly

i spent a week clearencing all the handles on my coffee mugs so i could shut the cabinet door. 2 days later i found a nicer set free on craigslist that fit in there perfectly

Wish we wooda been able to find the "Nicer set free on craigslist" for our valve covers. We opted for the nicer, but more expensive ones from Mikee.

Looks like June 10 is going to be a tight one to get to.

In the stock car days of the 80's, the crew would sometimes finish the car in the trailer on the way to the event.