Draglist.com Drag Racing

geez Z you should have asked me I have a BBC with heads you could have used for mock up in the garage taking up some space ( i tripped over them the other night . as for the foam headers try rollcage padding its a little easier to work with and not as gooey .

Thanks Stimpy. I didn't even give it much thought til' it came up in conversation yesterday. Then the next thing I knew, P-O-O-F there they were.

Cool Deal Pro!! Sounds like progress to me!

http://img.villagephotos.com/p/2006-12/ ... ads500.jpg

Yup. Any progress is good progress.

Thats cool Pro,
kinda reminds me of the nostalgia look , all rusty
and all,
like the 392 that we pulled out of a pond 8 yrs ago.
its cummin along, hows the headers fit ????

Better than I thought. Little tight on the passenger side (main frame rail).

It's still drippin' a little oil on the floor, since it was recently lightened up. Rods sorta' went where they shouldn'ta oughtta gone.

Pretty soon you'll have a real engine in there Gary. That car is cool!!!! What do you need yet?

What do you need yet?

Fiberglass deck lid.
Steering column
steering wheel
wiring harness
B-R-A-K-E lines
brake fluid
aluminum interior
fuel cell
fuel pump (s)
fuel lines
fuel Regulator
fuel delivery
fuel
drive shaft
drive shaft loop
drive shaft stove pipe
U joints
Assorted nuts, bolts, washers & fasteners of all kinds
wheelie bars
assorted brackets, tabs & mounts
go pedal
linkage in various places
glass
lexan
shifter
trans
engine
ignition
switches, lights, bells, buzzers & knobs
belts & hoses of various sizes & shapes
radiator

so i take it you should be good to go by tuesday ?

Sounds like a great project to me...it'll be on track soon...Keep pluggin' away at it and don't give up. You got it certified, at least! Great going! Cheers, WC1