Any help????
Posted: Wed Jan 10, 2007 11:58 am
thought I’d throw this out to everyone. I would like to get a pre drilled motor plate for my funny car. I’ve checked with several outlets (Mark Williams, SW, Chassis Shop) all have them, but they only make them out of aluminum.
If I can get one out of chrome moly, I can then lay my old one over it and trace the outside and cut it out on a band saw.
Any ideas, suggestions?
Dale Smith
Wings Electro Sales
Materials Mgr
(561) 798-6606 ph
(561) 798-6706 fax
(561) 309-8937 cel
__._,_.___
Messages in this topic (1)
If I can get one out of chrome moly, I can then lay my old one over it and trace the outside and cut it out on a band saw.
Any ideas, suggestions?
Dale Smith
Wings Electro Sales
Materials Mgr
(561) 798-6606 ph
(561) 798-6706 fax
(561) 309-8937 cel
__._,_.___
Messages in this topic (1)