Nitro Madness AA/FA

[Rapid Randy Baker]

Hey Thanks you guys!! It is getting close, I can't wait to fire it off!!

I am getting so "Stoked" to hammer it!

[Billy Mac]

I resemble that "stoked" remark, Randy ........"Maybe" I can lay down a black mark or two in the shop this weekend

[Solid Rock]

Looks good Rapid!!
Have you sat in the car with all your safety equuipment on yet?

It looks to me like your throttle foot will be real tight once you have your boots on. You might want to check that out. I've seen some have problems in that area with some ugly results.

[Rapid Randy Baker]

Thanks Rocky,

Yes to sitting in the car with the gear,,except for the shifter location. We just finished it yesterday, and I didn't have time to try doing just that last night.

I had my boots on when we were building the new throttle pedal.

We have plenty of room with the gear on,,,however it is a 1-inch narrower than the old car.

[Billy Mac]

ummmm....just for the record....."I" have small feet, Randy......

[jim sanders]

yea me too.. only problem is i can barely fall into my 'lectric lift chair theze days... much less climb into an f/c

[RH]

Waaaay to cool!
Fiats and Austins make give me flashbacks
The bullet shot is awesome with all that rainbow of anodizing.
Purple butterflies and idler support neat!

Thanks for sharing.

Ron

[Rapid Randy Baker]

Scott says my feet size are fine,,,but I seem to have only one postion to hold the right one,,,,FLAT TO THE FLOOR!!

Thanks Ron, I appreciate that.

[jim sanders]

Man would i give a body part away to see you guys at Gateway on a saturyday night testing along with Rear Gears car, Jake and the Caveman. somebody get a hold of Bret and put something together AFTER the national event

[RickO]

Looking good there Randy! Hmmm, it's got half a body, it flips=up, close the roof off, and add the other half and your a caveman!! I see a dark fiberglass cloaked future for your team......